Iai-america XSEL-KET Uživatelský manuál stáhnout pdf (Strana 353)

334

INTELLIGENT ACTUATOR

Appendix

5. Notes on Use of the Synchro Function

 As a rule, the synchro function must be implemented by coupling the master-axis and slave-axis

sliders using a bracket, etc.

 If the current position of the master axis is not aligned with that of the slave axis when the servo is

turned on, correction will be made automatically via fine-pitch movement. (The slave-axis slider will

move to the displayed coordinate position of the master-axis slider in a fine-drive mode.)

 The function to detect any positional shift that occurred while the power was turned off and correct it

after the servo is turned on may not be available depending on the model.

(This function is enabled if the controller was ordered as a synchro specification and “1” is set for

both the master axis and slave axis in “Axis-specific parameter No. 38, Encoder ABS/INC type.”)

 With a system subject to a relatively large positional shift while the servo power is turned off, after

turning on the servo obtain the current positions of the master axis and slave axis using a PRDQ

command (supported by main application version 0.35 or later), wait for the distance between the

current position of the slave axis and that of the master axis to be reduced to 0.3 mm or less, and

then issue operation commands. (See the reference program below.)

 Reference program

This program reads the current positions of the master axis and slave axis after the servo is turned

on, and turns ON global flag 600 when the distance between the two axes becomes 0.3 mm or less.

Operation commands are written so that they will be executed after 600 is turned ON.

SVON 1 Turn on the servos of the synchro axes.

BTOF 600 Turn OFF flag 600.

LET 100 1.000 Assign 1 (or any value larger than 0.2) to variable 100.

DWGT 100 0.300

End the loop when the value in variable 100 becomes 0.3 or less

(= when the distance between the master axis and the slave axis

becomes 0.3 mm or less).

PRDQ 1 100 Assign the current position of the master axis to variable 100.

PRDQ 2 101 Assign the current position of the slave axis to variable 101.

SUB 100 *101 Subtract the value in variable 101 from the value in variable 100.

IFLT 100 0.000 If the result is a negative value,

MULT 100 -1.000 Multiply the result by –1 to convert it to a positive value.

EDIF

EDDO

BTON 600 Turn ON flag 600.

EXIT

1 2 ... 348 349 350 351 352 353 354 355 356 357 358 ... 435 436

Žádné komentáře

Iai-america XSEL-KET Uživatelský manuál Strana 353